[. . . ] Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. They are double-insulated in accordance with European Standard and can, therefore, also be used from sockets without earth wire. for public low-voltage distribution systems of between 220V and 250V Switching operations of electric apparatus cause voltage fluctuations. [. . . ] Make sure that the arrow on the wheel should point in the same direction as the arrow on the tool. The handy rip fence (guide rule) allows you to do extra-accurate straight cuts. Simply slide the rip fence up snugly against the side of the workpiece and secure it in position with the clamp screw on the front of the base. But if it is off, adjust the adjusting screw with a screwdriver while squaring the blade with the base using a triangular rule, try square, etc. Cleaner cutting operations can be performed by connecting this tool to a Makita vacuum cleaner. For straight cuts, align the right edge of the notch in the front of the base with your cutting line on the workpiece. For 45° bevel cuts, align the left edge of the notch in the front of the base with it. CAUTION: Always be sure that the tool is switched off and unplugged before carrying out any work on the tool. CAUTION: Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the ``OFF'' position when released. To prevent the switch trigger from being accidentally pulled, a lock-off button is provided. If the cutting action of the diamond wheel begins to diminish, use an old discarded coarse grit bench grinder wheel or concrete block to dress the diamond wheel. To do this, tightly secure the bench grinder wheel or concrete block and cut in it. To maintain product safety and reliability, repairs, maintenance or adjustment should be carried out by a Makita Authorized Service Center. Grasp the rear handle with your right hand, the front grip with your left. [. . . ] The use of any other accessories or attachments might present a risk of injury to persons. The accessories or attachments should be used only in the proper and intended manner. Is in compliance with the following standards or standardized documents, HD400, EN50144, EN55014, EN61000 in accordance with Council Directives, 73/23/EEC, 89/336/EEC and 98/37/EC. [. . . ]